HITACHI DVPF3EUK
Manual de Usuario

SETTING THE CLOCK
VCR
This DVD/VCR incorporates a 24-hour clock. The clock must be set for the Automatic Timer Recording function to operate correctly. Your DVD/VCR is fitted with PDC (See page27). If the PDC signal is available in your area, your DVD/VCR can get the current time from your local PDC broadcast. It keeps track of the time constantly referring to the time broadcasted by your PDC broadcast. If you want to use this feature, refer to �AUTO CLOCK SETTING� in the next section. MANUAL CLOCK SETTING

6 Likewise, set the relevant month, day, hour,
and minute.

7 Press MENU to start the clock.
Notes � In the steps 5 and 6, you can go back to the item you want to correct by pressing Arrow (s ). � Although seconds are not displayed, they begin counting from 00 when you exit by pressing MENU. Use this feature to synchronise the clock with the correct time. � When unplugging the power-cord or if there is a power failure for more than thirty minutes, you may have to reset the clock. AUTO CLOCK SETTING

1 Press MENU. 2 Press Arrow (o/p) to select �INITIAL�, then
press Arrow (B).
MENU TIMER SET UP INITIAL

1 Follow the steps through 1 to 3 in �MANUAL
CLOCK SETTING�.

2 Press Arrow (o/p) to select �AUTO�. Then,
press Arrow (B) to select [ON].

3 Turn off the DVD/VCR once by pressing
(Standby/Power ON).

3 Press Arrow (o/p) to select �CLOCK�, then
press Arrow (B).
INITIAL CH TUNING CLOCK RF OUT

4 Press Arrow (o/p) to select �MANUAL�, then
press Arrow (B).

5 Press Arrow (o/p) until the relevant year
appears, then press Arrow ( B).
CLOCK YEAR MONTH DAY HOUR MINUTE 2003 01 0 1 WE __ __

� The clock will appear on the TV screen when you turn on the DVD/VCR again. Notes � Channel Presetting must be set before the Auto Clock is set. � The DVD/VCR refers to the channel which was memorised into position 01. The PDC channel must therefore be set to position 01. � The clock cannot be set automatically if you are not receiving a channel that carries a time signal in your area. In this case, set the clock manually. � Once the auto clock setting is performed, the DVD/VCR will correct the current time by receiving PDC broadcasts whenever you turn off the DVD/VCR. � The DVD/VCR will correct the current time automatically at 8:00. � Between 23:00~1:00, the AUTO CLOCK function does not work even if the DVD/VCR�s power is

TUNING
Tuning of broadcast channels not already preset in the MANUAL TUNING DVD/VCR can be performed in two ways. � Each channel is tuned manually and individually. AUTOMATIC TUNING Follow the steps laid out in the �MANUAL TUN� By �AUTOMATICALLY� tuning channels and placING� section. ing them in sequential order in the DVD/VCR�s Before you preset Channel ... memory i.e. the first channel found will be memo- � It is necessary to set the video channel if your rised into the DVD/VCR�s channel position 1, the DVD/VCR is connected to the TV via the aerial second channel found will be memorised into the cable, and TV channel 35 is employed for broadcastDVD/VCR�s channel position 2 and so on. ing, or interference lines appear on the picture. Please � Execution of the �Automatic� tuning cancels all the refer to �Video Channel Setting�. preset channels. DO NOT use this feature if you intend to use some of the pre-tuned channels. Use the �Manual� tuning function to tune in the additional channels you require. � 18 � EN
2C15